Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Kia Rondo L4-2.4LFACTORY OEM SERVICE PROCEDURE
Spark Plug: Service and Repair
INSPECTION
1. Remove the ignition coil connector(A).
2. Remove the ignition coil(A).
NOTE:
When removing the ignition coil connector, pull the lock pin(A) and push the clip(B).
3. Using a spark plug socket, remove the spark plug.
CAUTION:
Be careful that no contaminates enter through the spark plug holes.
4. Inspect the electrodes(A) and ceramic insulator(B).
INSPECTION OF ELECTRODES
5. Check the electrode gap (A).
Standard : 1.0 - 1.1 mm (0.0394 - 0.0433 in.)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.