2008 Kia Rio Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Fuel Tank: Removal

  1. Preparation
    1. Remove the rear seat cushion. Refer to REAR SEAT .
    2. Remove the service cover (A).
      Fig 1: Identifying Service Cover
      G04862383Courtesy of KIA MOTORS AMERICA, INC.
    3. Disconnect the fuel pump connector (A).
      Fig 2: Identifying Fuel Pump Connector
      G04862384Courtesy of KIA MOTORS AMERICA, INC.
    4. Start the engine and wait until fuel in fuel line is exhausted.
    5. After engine stalls, turn the ignition switch to OFF position.
  2. Disconnect the fuel feed line (A) and canister hose (B).
    Fig 3: Identifying Fuel Feed Line And Canister Hose
    G04862389Courtesy of KIA MOTORS AMERICA, INC.
  3. Life the vehicle.
  4. Remove the center muffler. Refer to EXHAUST PIPE .
  5. Support the fuel tank with a jack.
  6. Unscrew the brake hose mounting bolts (A).
    Fig 4: Identifying Brake Hose Mounting Bolts
    G04862390Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.