Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2008 Kia Rio Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Floor Console Replacement

NOTE:

When prying with a flat-up screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.

Remove the front seat. See REPLACEMENT .
After disconnecting the console switch assembly (A), remove the connector.

Fig 1: Identifying Console Switch Assembly
Remove the console upper cover (A).

Fig 2: Identifying Console Upper Cover
Remove the parking brake cover (A).

Fig 3: Identifying Parking Brake Cover
Loosening the console mounting bolt and clip, remove the console assembly (A).

Fig 4: Identifying Console Assembly, Mounting Bolt And Clips
Installation is the reverse of removal.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.