Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Kia AmantiFACTORY OEM SERVICE PROCEDURE
Automatic Transaxle System
- General
- Automatic Transaxle System
- Description
- Mechanical System
- Service Adjustment Procedure
- Inspection Chart For Diagnosis Trouble Codes (DTC)
- DTC P0707 Transaxle Range Switch - Low Input
- DTC P0708 Transaxle Range Switch - High Input
- DTC P0711 Transaxle Fluid Temperature Sensor Rationality
- DTC P0712 Fluid (Oil) Temperature Sensor Circuit - Low
- DTC P0713 Fluid (Oil) Temperature Sensor Circuit - High
- DTC P0717 Input Speed Sensor Circuit - No Signal
- DTC P0722 Output Speed Sensor Circuit - No Signal
- DTC P0731 Gear 1 Incorrect Ratio
- DTC P0732 Gear 2 Incorrect Ratio
- DTC P0733 Gear 3 Incorrect Ratio
- DTC P0734 Gear 4 Incorrect Ratio
- DTC P0735 Gear 5 Incorrect Ratio
- DTC P0741 Torque Converter Clutch Circuit - Stuck Off
- DTC P0742 Torque Converter Clutch Circuit - Stuck On
- DTC P0743 Torque Converter Clutch Circuit - Electrical
- DTC P0748 Pressure Control Solenoid Valve A - Electrical
- DTC P0750 Shift Control Solenoid Valve A Circuit Malfunction
- DTC P0755 Shift Control Solenoid Valve B Circuit Malfunction
- DTC P0760 Shift Control Solenoid Valve C Circuit Malfunction
- DTC P0765 Shift Control Solenoid Valve D Circuit Malfunction
- DTC P0770 Shift Control Solenoid Valve E Circuit Malfunction
- DTC P0885 A/T Relay Circuit Malfunction
- DTC P0890 At Relay - Low Circuit
- DTC P0891 At Relay - Open Circuit
- Automatic Transaxle
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.