Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Kia AmantiFACTORY OEM SERVICE PROCEDURE
Charging System
CHARGING SYSTEM SPECIFICATIONS
| Items | Specification | |
|---|---|---|
| Alternator | Rate voltage | 13.5 V, 130A |
| Speed in use | 1,000 ~ 18,000 RPM | |
| Voltage regulator | IC regulator built-in type | |
| Regulator setting voltage | 14.2 ~ 14.8 V (5000 RPM, 10A, 25iAEC) | |
| Battery | Type | CMF 80AH |
| Cold cranking amperage [at - 18iAEC(-0.4iAEF)] | 660 A | |
| Reserve capacity | 145 min | |
| Specific gravity [at 25iAEC(77iAEF)] | 1.280 i 3/4 0.01 | |
NOTE:
- COLD CRANKING AMPERAGE is the amperage a battery can deliver for 30 seconds and maintain a terminal voltage of 7.2V or greater at a specified temperature.
- RESERVE CAPACITY RATING is amount of time a battery can deliver 25A and maintain a minimum terminal voltage of 10.5V at 26.7°C (80.1°F).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.