Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Kia Spectra5 2.0 1, AutomaticFACTORY OEM SERVICE PROCEDURE
Overrunning Clutch: Notes
- Slide the overrunning clutch along the shaft. Replace it if does not slide smoothly.
- Rotate the overrunning clutch both ways. If overrunning clutch locks in one direction and rotates smoothly in other direction, overrunning clutch is okay. If it does not lock in either direction of it locks in both directions, replace it. See Fig 1.
- If the starter drive gear is worn or damaged, replace the overrunning clutch assembly (the gear is not available separately). Check the condition of the flywheel or torque converter ring gear if the starter drive gear teeth are damaged.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.