Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2007SPECTRA L4-2.0LREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINESYSTEM SPECIFICATIONSCYLINDER HEAD
2007 Kia Spectra L4-2.0L
Cylinder Head
2007 Kia Spectra L4-2.0LSECTION Cylinder Head
Note: "Head Bolts are Reusable"
Cylinder Head
Using 8 mm and 10 mm hexagon wrench, install and tighten the 10 cylinder head bolts and plate washers, in several passes, in the sequence shown.
Tightening torque :
M10 22.6 - 26.5 N-m (2.3 - 2.7 kg-m, 16.6 - 19.5 lb-ft) + 60° ~ 65° + 60° ~ 65°
M12 27.5 - 31.4 N-m (2.8 - 3.2 kg-m, 20.3 - 23.1 lb-ft) + 60° ~ 65° + 60° ~ 65°
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.