Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Kia Sorento Base, A5SR2FACTORY OEM SERVICE PROCEDURE
Automatic Transaxle System DTCS
AUTOMATIC TRANSAXLE SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Item |
|---|---|
| P0601 | INTERNAL CONTROL MODULE MEMORY CHECK SUM ERROR |
| P0641 | SENSOR REFERENCE VOLTAGE "A" CIRCUIT - OPEN |
| P0705 | TRANSMISSION RANGE SENSOR CIRCUIT MALFUNCTION (PRND Input) |
| P0711 | TRANSMISSION FLUID TEMPERATURE SENSOR A RATIONALITY |
| P0712 | TRANSMISSION FLUID TEMPERATURE SENSOR A STUCK OFF (HIGH INPUT) |
| P0713 | TRANSMISSION FLUID TEMPERATURE SENSOR A STUCK ON (LOW INPUT) |
| P0716 | A/T INPUT SPEED SENSOR CIRCUIT - OPEN or SHORT (GND) |
| P0717 | A/T INPUT SPEED SENSOR CIRCUIT - NO SIGNAL |
| P0721 | A/T OUTPUT SPEED SENSOR CIRCUIT - OPEN or SHORT (GND) |
| P0731 | GEAR 1 INCORRECT RATIO |
| P0732 | GEAR 2 INCORRECT RATIO |
| P0733 | GEAR 3 INCORRECT RATIO |
| P0734 | GEAR 4 INCORRECT RATIO |
| P0735 | GEAR 5 INCORRECT RATIO |
| P0741 | TORQUE CONVERTER CLUTCH STUCK OFF |
| P0743 | TCC CONTROL SOLENOID VALVE CIRCUIT - OPEN or SHORT (GND) |
| P0748 | PRESSURE CONTROL SOLENOID VALVE-A CIRCUIT - OPEN or SHORT (GND) |
| P0753 | SHIFT SOLENOID "A (I/C SOLENOID)" CIRCUIT - OPEN or SHORT (GND) |
| P0758 | SHIFT SOLENOID "B (FR/B SOLENOID)" CIRCUIT - OPEN or SHORT (GND) |
| P0763 | SHIFT SOLENOID "C (D/C SOLENOID)" CIRCUIT - OPEN or SHORT (GND) |
| P0768 | SHIFT SOLENOID "D (H & LR/C SOLENOID)" CIRCUIT - OPEN or SHORT (GND) |
| P0773 | SHIFT SOLENOID "E (LC/B SOLENOID)" CIRCUIT - OPEN or SHORT (GND) |
| P0819 | UP AND DOWN SHIFT SWITCH TO TRANSMISSION RANGE CORRELATION |
| U0001 | CAN COMMUNICATION BUS |
| U0100 | LOST COMMUNICATION WITH PCM "A" |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
