Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Window Switch
2007 Kia Sedona V6-3.8LSECTION Power Window Switch
REPLACEMENT
DRIVER/ASSIST DOOR MODULE (DDM/ADM)
1. Remove (-) negative battery terminal.
2. Remove the front door trim panel.
3. Disconnect the door module mounting screws (5EA) after disconnecting the module connectors (3EA) from the motor.
4. Remove the door module (DDM/ADM) (A) from the front door trim panel.
5. Installation is the reverse of removal.
SLIDING POWER WINDOW SWITCH
1. Remove (-) negative battery terminal.
2. Disconnect the connector (B) after removing the sliding power window switch (A) from the B pillar trim (C).
3. Installation is the reverse of removal.
QUARTER GLASS SWITCH
1. Remove (-) negative battery terminal.
2. Disconnect the connector (B) after removing the quarter glass switch (A) from the rear cargo area luggage trim.
3. Installation is the reverse of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.