2007 Kia Sedona BaseFACTORY OEM SERVICE PROCEDURE

Abs Control

  1. NORMAL BRAKING without ABS
    OPERATION CHART

      Inlet valve(EV) Outlet valve(AV) Pump motor
    Operation Open Close OFF
    Fig 1: ABS Control Circuit Diagram - Normal Braking Without ABS
    G04883832Courtesy of KIA MOTORS AMERICA, INC.
  2. DECREASE MODE
    OPERATION CHART

      Inlet valve(EV) Outlet valve(AV) Pump motor
    Operation Close Open ON(Motor speed control)
    Fig 2: ABS Control Circuit Diagram - Decrease Mode
    G04883833Courtesy of KIA MOTORS AMERICA, INC.
  3. HOLD MODE
    OPERATION CHART

      Inlet valve(EV) Outlet valve(AV) Pump motor
    Operation Close Close OFF
    Fig 3: ABS Control Circuit Diagram - Hold Mode
    G04883834Courtesy of KIA MOTORS AMERICA, INC.
  4. INCREASE MODE
    OPERATION CHART

      Inlet valve(EV) Outlet valve(AV) Pump motor
    Operation Open Close OFF
    Fig 4: ABS Control Circuit Diagram - Increase Mode
    G04883835Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.