2007 Kia Sedona BaseFACTORY OEM SERVICE PROCEDURE

Power Seat Module (IMS Module): Replacement

  1. Disconnect the negative (-) battery terminal.
  2. Remove the seat back (Refer to FRONT SEAT ).
    Fig 1: Identifying Seats
    G04884886Courtesy of KIA MOTORS AMERICA, INC.
  3. Remove the power seat module after removing the power seat module mounting nuts (4 EA) and connector (3 EA).
    Fig 2: Identifying Power Seat Module And Mounting Nuts
    G04885140Courtesy of KIA MOTORS AMERICA, INC.
  4. Installation is the reverse of removal.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.