2007 Kia Rondo V6-2.7LFACTORY OEM SERVICE PROCEDURE

Oxygen Sensor: Testing and Inspection

HEATED OXYGEN SENSOR (HO2S)

INSPECTION

FUNCTION AND OPERATION PRINCIPLE

Factory service manual diagram



Factory service manual diagram



Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed upstream and downstream of the Manifold Catalyst Converter (MCC). After it compares oxygen consistency of the atmosphere with the exhaust gas, it transfers the oxygen consistency of the exhaust gas to the PCM. When A/F ratio is rich or lean, it generates approximately 1 V or 0 V respectively. In order that this sensor normally operates, the temperature of the sensor tip is higher than 370 °C (698 °F). So it has a heater which is controlled by the PCM duty signal. When the exhaust gas temperature is lower than the specified value, the heater warms the sensor tip.

SPECIFICATION
A/F Ratio Output Voltage (V)

RICH 0.80 - 0.92
LEAN 0.1

Item Specification
Heater Resistance (ohm) 3.0 - 4.0 ohms at 21 °C (69.8 °F)

Waveform:

Factory service manual diagram



WAVEFORM


Circuit Diagram:

Factory service manual diagram



CIRCUIT DIAGRAM

COMPONENT INSPECTION
1. Check signal waveform of HO2S using a scantool.

Specification: Refer to "waveform".

2. Disconnect the HO2S connector.

Factory service manual diagram



3. Measure resistance between HO2S heater terminals 3 and 4.
4. Check that the resistance is within the specification.

Specification: Refer to SPECIFICATION.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.