Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Kia Rondo L4-2.4LFACTORY OEM SERVICE PROCEDURE
Cruise Control: Testing and Inspection
CRUISE CONTROL SYSTEM
TROUBLESHOOTING
Before starting troubleshooting, inspect each of the following sections, and if there is an abnormality, carry out a repair.
1. Check that the actuator and pulley assembly are all normal.
2. Check if the pulley assembly and the movement of cables are working smoothly.
3. Check if there is no excessive play or tension in each cable.
TROUBLESHOOTING PROCEDURES
First, select the applicable malfunction symptom from the "TROUBLE SYMPTOM CHARTS".
Determine the condition of all function circuits.
1. Make the following preliminary inspections.
- Check that the installation of the actuator, accelerator cable are correct, and that the cables and links are securely connected.
- Check that the accelerator pedal moves smoothly.
- Adjust the cable so there is not excessive tension or excessive play on the accelerator cable.
- Check that the actuator and unit assembly, cruise main, control switch and the connector of each cancel switch are connected securely.
2. Check in the sequence indicated in the "TROUBLE SYMPTOM CHARTS".
3. If a normal condition is indicated, replace the cruise control module.



TROUBLE SYMPTOM CHARTS
TROUBLESHOOTING
Before starting troubleshooting, inspect each of the following sections, and if there is an abnormality, carry out a repair.
1. Check that the actuator and pulley assembly are all normal.
2. Check if the pulley assembly and the movement of cables are working smoothly.
3. Check if there is no excessive play or tension in each cable.
TROUBLESHOOTING PROCEDURES
First, select the applicable malfunction symptom from the "TROUBLE SYMPTOM CHARTS".
Determine the condition of all function circuits.
1. Make the following preliminary inspections.
- Check that the installation of the actuator, accelerator cable are correct, and that the cables and links are securely connected.
- Check that the accelerator pedal moves smoothly.
- Adjust the cable so there is not excessive tension or excessive play on the accelerator cable.
- Check that the actuator and unit assembly, cruise main, control switch and the connector of each cancel switch are connected securely.
2. Check in the sequence indicated in the "TROUBLE SYMPTOM CHARTS".
3. If a normal condition is indicated, replace the cruise control module.
Trouble Symptom Charts Part 1:
Trouble Symptom Charts Part 2:
Trouble Symptom Charts Part 3:
TROUBLE SYMPTOM CHARTS
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
