Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Kia Rondo BaseFACTORY OEM SERVICE PROCEDURE
Front Strut Assembly: Removal
- Remove the front wheel and tire.CAUTION: Be careful not to damage the hub bolts when removing the front wheel and tire.
- Remove the brake hose and the wheel speed sensor bracket from the front strut assembly by loosening the mounting bolts (A).
- Disconnect the stabilizer link (A) with the front strut assembly after loosening the nut.
- Disconnect the front strut assembly (A) with the knuckle by loosening the bolt and nut.
- Remove the front strut assembly from the wheel housing panel by loosening the mounting nuts (A).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
