2007 Kia Rondo BaseFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Connectors

CONNECTORS LOCATION

Component Location
AA11 (Yellow, 4 Pin) Under center of dash. See Figure.
CA11 (Yellow, 4 Pin) Behind right kick panel. See Figure.
CC01 (Gray, 4 Pin) Top right front of engine. See Figure.
CC02 (Gray, 4 Pin) Top rear of engine. See Figure.
CF12 (White, 20 Pin) Behind right kick panel. See Figure.
EA11 (Yellow, 4 Pin) Behind left kick panel. See Figure.
EC12 (White, 10 Pin) Behind left side of dash. See Figure.
EE01 (Black, 1 Pin) Front of engine compartment. See Figure.
EE12 (Black, 6 Pin) Behind left end of front bumper. See Figure.
EF12 (White, 22 Pin) Behind left kick panel. See Figure.
EM11 (Black, 42 Pin) Behind left kick panel. See Figure.
EM21 (White, 8 Pin) Behind left kick panel. See Figure.
FD01 (White, 39 Pin) In left "A" pillar. See Figure.
FD02 (Gray/White, 39 Pin) In right "A" pillar. See Figure.
FD03 (White, 14 Pin) At right "B" pillar. See Figure.
FD04 (White, 15 Pin) At left "B" pillar. See Figure.
FR01 (White, 16 Pin) Behind left side of dash. See Figure.
FR11 (White, 12 Pin) Left rear of roof. See Figure.
FR21 (Black, 4 Pin) Under left rear of vehicle. See Figure.
FR31 (White, 2 Pin) Left rear of roof. See Figure.
FS01 (White, 8 Pin) Under driver's seat. See Figure.
FS02 (White, 8 Pin) Under front passenger seat. See Figure.
MA11 (Yellow, 14 Pin) Behind center of dash. See Figure.
MA21 (White, 20 Pin) On right side of HVAC assembly. See Figure.
MA31 (White, 20 Pin) On right side of HVAC assembly. See Figure.
MC12 (Black, 39 Pin) Behind right kick panel. See Figure.
MF12 (Gray, 39 Pin) Behind left kick panel. See Figure.
MF32 (Blue, 39 Pin) Behind right kick panel. See Figure.
RR11 (White, 14 Pin) Left side of tailgate. See Figure.
RR21 (White, 2 Pin) Left side of tailgate. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.