Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Kia Rondo BaseFACTORY OEM SERVICE PROCEDURE
Lighting System: Specification
LIGHTING SYSTEM SPECIFICATION
| Items | Bulb Watt (W) | |
|---|---|---|
| Head lamp (High) | 55 | |
| Head lamp (Low) | 55 | |
| Front turn signal lamp | 28 | |
| Front fog lamp | 27 | |
| Rear stop/tail lamp (Outside) | 28/8 | |
| Back up lamp | 18 | |
| Rear turn signal lamp | 27 | |
| License plate lamp | 5 | |
| Side mark (Front / Rear) | 5 | |
| Room lamp | Center - Room lamp | 10 |
| Rear - Luggage lamp | 5 | |
| Overhead console lamp (Map lamp) | 10 | |
| High mounted stop lamp | LED | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.