2007 Kia Rondo BaseFACTORY OEM SERVICE PROCEDURE

Immobilizer Control Unit: Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the driver crash pad lower panel (A) after removing side cover. (Refer to the "CRASH PAD ").
    Fig 1: Identifying Driver Crash Pad Lower Panel
    G05188093Courtesy of KIA MOTORS AMERICA, INC.
  3. Remove the shroud (A) after removing the fixed screws (3EA).
    Fig 2: Identifying Shroud
    G05188094Courtesy of KIA MOTORS AMERICA, INC.
  4. Disconnect the 5P connector of the SMARTRA unit and then remove the SMARTRA unit (A) after loosening a nut.
    Fig 3: Identifying SMARTRA Unit
    G05188095Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.