Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2007 Kia Rio5 AutomaticFACTORY OEM SERVICE PROCEDURE

DTC P2232 O2 Sensor Signal Circuit Shorted To Heater Circuit (Sensor 2): DTC Detecting Condition

DTC DETECTING CONDITION AND POSSIBLE CAUSES

Item	Detecting Condition	Possible Cause
DTC Strategy	Rationality check	Poor connection Short to power in signal circuit B1S2 ECM/PCM
Enable Conditions	After enough heated Battery voltage > 10.7V Catalyst temperature (model) < 800°C (1472°F) Time after dew point end detected > 10 sec
Threshold Value	Counter of [ Δ ushk > 2V during 0.04 secafter heater on-->off] > 5 times
Diagnostic Time	2 driving cycle
Δushk: Sum of the signal voltage change value (B1S2) * B1S1: upstream oxygen sensor / B1S2: downstream oxygen sensor

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.