Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Kia Rio Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Hi-Scan (Pro) Check: Notes
- Turn the ignition switch OFF.
- Connector the Hi-scan (pro) to the 16P data link connector located the driver's side kick panel.
- Turn the ignition switch ON.
- Check for diagnostic trouble using the Hi-scan (pro)
- After completion trouble of the repair or correction of the problem, erase the stored fault codes the clear key on the Hi-scan (pro).
- Disconnect the Hi-scan (pro) from the 16P data link connector.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.