Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Kia AmantiFACTORY OEM SERVICE PROCEDURE
Automatic Transaxle DTCS
AUTOMATIC TRANSAXLE DIAGNOSIS TROUBLE CODES (DTC) LIST
| Code | Item |
|---|---|
| P0707 | TRANSAXLE RANGE SWITCH CIRCUIT LOW INPUT |
| P0708 | TRANSAXLE RANGE SWITCH CIRCUIT HIGH INPUT |
| P0711 | TRANSAXLE FLUID TEMPERATURE SENSOR RATIONALITY |
| P0712 | TRANSAXLE FLUID TEMPERATURE SENSOR CIRCUIT LOW INPUT |
| P0713 | TRANSAXLE FLUID TEMPERATURE SENSOR CIRCUIT HIGH INPUT |
| P0717 | A/T INPUT SPEED SENSOR CIRCUIT - OPEN or SHORT (GND) |
| P0722 | AT OUTPUT SPEED SENSOR CIRCUIT - OPEN or SHORT (GND) |
| P0731 | GEAR 1 INCORRECT RATIO |
| P0732 | GEAR 2 INCORRECT RATIO |
| P0733 | GEAR 3 INCORRECT RATIO |
| P0734 | GEAR 4 INCORRECT RATIO |
| P0735 | GEAR 5 INCORRECT RATIO |
| P0741 | TORQUE CONVERTER CLUTCH STUCK OFF |
| P0742 | TORQUE CONVERTER CLUTCH STUCK ON |
| P0743 | TORQUE CONVERTER CLUTCH CONTROL SOLENOID VALVE - OPEN or SHORT (GND) |
| P0748 | VFS solenoid - OPEN or SHORT (GND) |
| P0750 | LOW and REVERSE SOLENOID VALVE CIRCUIT - OPEN or SHORT (GND) |
| P0755 | UNDERDRIVE SOLENOID VALVE CIRCUIT - OPEN or SHORT (GND) |
| P0760 | SECOND SOLENOID VALVE CIRCUIT - OPEN or SHORT (GND) |
| P0765 | OVERDRIVE SOLENOID VALVE CIRCUIT - OPEN or SHORT (GND) |
| P0770 | RED SOLENOID |
| P0885 | A/T CONTROL RELAY - OPEN or SHORT (GND) |
| P0890 | TCM power Relay sense circuit low |
| P0891 | TCM power Relay sense circuit High |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
