Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Kia AmantiFACTORY OEM SERVICE PROCEDURE
Abs Anti-Lock Brake System DTCS
ABS ANTI-LOCK BRAKE SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Trouble description | |
|---|---|---|
| C1101 | Battery Voltage High | Steering wheel sensor failure |
| Other | ||
| C1102 | Battery Voltage Low | 9.3±0.3V for 210ms |
| Steering wheel sensor failure | ||
| Other | ||
| C1200 | Wheel Speed Sensor Front-LH Open/Short | |
| C1201 | Wheel Speed Sensor Front-LH Range / Performance / Intermittent | |
| C1202 | Wheel Speed Sensor Front-LH Invalid/no Signal | |
| C1203 | Wheel Speed Sensor Front-RH Open/Short | |
| C1204 | Wheel Speed Sensor Front-RH Range / Performance / Intermittent | |
| C1205 | Wheel Speed Sensor Front-RH Invalid/no Signal | |
| C1206 | Wheel Speed Sensor Rear-LH Open/Short | |
| C1207 | Wheel Speed Sensor Rear-LH Range / Performance / Intermittent | |
| C1208 | Wheel Speed Sensor Rear-LH Invalid/no Signal | |
| C1209 | Wheel Speed Sensor Rear-RH Open/Short | |
| C1210 | Wheel Speed Sensor Rear-RH Range / Performance / Intermittent | |
| C1211 | Wheel Speed Sensor Rear-RH Invalid/no Signal | |
| C1235 | Primary Pressure Sensor-Electrical | |
| C1236 | Secondary Pressure Sensor-Electrical | |
| C1237 | Pressure Sensor-Signal | |
| C1259 | Steering Angle Sensor-Electrical | |
| C1260 | Steering Angle Sensor-Signal | |
| C1282 | Yaw Rate & Lateral G Sensor-Electrical | |
| C1283 | Yaw Rate & Lateral G Sensor-Signal | |
| C1503 | TCS/ESC Switch Error | |
| C1513 | Brake Switch Error | |
| C1604 | ECU Hardware Error | EEPROM fail |
| Sensor Supply Voltage Failure, CAN 1 or 2 Failure, ESC operation over 15sec. | ||
| Temperature sensor malfunction | ||
| Other | ||
| C1611 | CAN Time-out ECM | |
| C1612 | CAN Time-out TCM | |
| C1616 | CAN Bus off | |
| C1700 | Byte Coding Error | |
| C2112 | Valve Relay Error | |
| C2227 | Excessive Temperature Of Brake Disc | |
| C2402 | Motor Electrical | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
