2006 Kia Rio L4-1.6LFACTORY OEM SERVICE PROCEDURE

Sequences

Main Bearing Cap
Install the main bearing cap bolts.

NOTE: The main bearing cap bolts are tightened in 2 progressive steps.
If any of the bearing cap bolts in broken or deformed, replace it.

Apply a light coat of engine oil on the threads and under the bearing cap bolts.
Install and uniformly tighten the 10 bearing cap bolts (A), in several passes, in the sequence shown.

Factory service manual diagram




Check that the crankshaft turns smoothly.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.