Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Kia Rio L4-1.6LFACTORY OEM SERVICE PROCEDURE
Alignment: Specifications
FRONT (Power Steering)
Toe -2 ~ 2 mm (-0.078 ~ 0.0787 in)
Camber 0° ± 30'
Caster
to ground 4°00' ± 30'
to body 4°30'
Kin pin angle 13° ± 30'
FRONT (Manual Steering)
Toe -2 ~ 2 mm (-0.078 ~ 0.0787 in)
Camber 0° ± 30'
Caster
to ground 0°35' ± 30'
to body 1°05'
Kin pin angle 13° ± 30'
REAR
Toe 2 ~ 6 mm (0.078 ~ 0.236 in)
Camber -1° ± 30'
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
