Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Kia Rio L4-1.6LFACTORY OEM SERVICE PROCEDURE
Rear Wheel Alignment
REAR WHEEL ALIGNMENT
TOE-IN
Standard value
Toe-in mm (inch): 2 - 6 (0.078 - 0.236)
CAMBER
Standard value: -1° ± 30'
WHEEL RUNOUT
1. Jack up the vehicle and support it with jack stands.
2. Measure the wheel runout with a dial indicator as illustrated.
3. Replace the wheel if the wheel runout exceeds the limit.

WHEEL NUT TIGHTENING
1. Tightening torque.
Tightening torque: 90 - 110 Nm (9 - 11 kgf-m, 65 - 79 ft. lbs.)
CAUTION: When using an impact gun, final tightening torque should be chocked using a torque wrench.
2. Tightening order.
Check the torque again after tightening the wheel nuts diagonally.

TOE-IN
Standard value
Toe-in mm (inch): 2 - 6 (0.078 - 0.236)
CAMBER
Standard value: -1° ± 30'
WHEEL RUNOUT
1. Jack up the vehicle and support it with jack stands.
2. Measure the wheel runout with a dial indicator as illustrated.
3. Replace the wheel if the wheel runout exceeds the limit.
WHEEL NUT TIGHTENING
1. Tightening torque.
Tightening torque: 90 - 110 Nm (9 - 11 kgf-m, 65 - 79 ft. lbs.)
CAUTION: When using an impact gun, final tightening torque should be chocked using a torque wrench.
2. Tightening order.
Check the torque again after tightening the wheel nuts diagonally.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
