2006 Kia Rio L4-1.6LFACTORY OEM SERVICE PROCEDURE

Heater Control Unit

HEATER CONTROL UNIT REPLACEMENT

Factory service manual diagram



1. Remove the center lower tray (A).

Factory service manual diagram



2. After loosen the center facia lower panel mounting screw, remove the center facia lower panel (A). Disconnect the heater control unit connector (B).

Factory service manual diagram



3. Disconnect the heater control cable (A).

Factory service manual diagram



4. Loosen the heater control unit 0mounting screw. Remove the heater control unit (A).
5. Installation is the reverse of removal.

NOTE: Make sure the connector is plugged in properly.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.