2005 Kia Optima L4-2.4LFACTORY OEM SERVICE PROCEDURE

Brake Caliper

TIGHTENING TORQUE
Caliper guide rod bolt 22 - 32 Nm (220 - 320 kg-cm, 16 - 24 ft. lbs.)
Caliper assembly to knuckle 69 - 85 Nm (690 - 850 kg-cm, 51 - 63 ft. lbs.)
Brake hose to front caliper 25 - 30 Nm (250 - 300 kg-cm, 18 - 22 ft. lbs.)
Rear caliper to carrier 50 - 60 Nm (500 - 600 kg-cm, 36 - 43 ft. lbs.)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.