2004 Kia Optima EX, 2.4 6FACTORY OEM SERVICE PROCEDURE

Fuel Tank: Installation

  1. Connect the leveling hose to the tank and approximately 40 mm (1.6 in.) at the filler neck.
    Fig 1: Connecting The Leveling Hose To The Tank
    G02535574Courtesy of KIA MOTORS AMERICA, INC.
  2. When connecting the filler hose, connect the end with the shorter straight pipe to the tank side.
  3. Confirm that the pad is fully bonded to the fuel tank. Install the fuel tank by tightening the self-locking nuts to the tank bands until the rear end of the tank band contacts the body.
    Fig 2: Installing The Fuel Tank
    G02535575Courtesy of KIA MOTORS AMERICA, INC.
  4. Connect the vapor hose and return hose. Attach the fuel hose to the line as shown in the illustration.
    Fig 3: Connecting The Vapor And Return Hoses
    G02535576Courtesy of KIA MOTORS AMERICA, INC.
  5. To connect the high pressure hose to the fuel pump, temporarily tighten the flare nut by hand, and then tighten it to the specified torque. Be careful that the fuel hose does not twist.

    Tightening torque 

    High pressure hose flare nut : 30~40 Nm (300~400 kg.cm, 22~29 lb-ft)

    NOTE: When tightening the flare nut, be careful not to bend or twist the line to prevent damage to the fuel pump connection.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.