2004 Kia AmantiFACTORY OEM SERVICE PROCEDURE

Output Current Test: Test

NOTE: After the engine starts up, the charging current quickly drops. Therefore, the operation must be done quickly to read the maximum current value correctly.
  1. Check to see that the voltmeter reads as the same value as the battery voltage. If the voltmeter reads zero volt, and the open circuit in the wire between the generator "B" terminal and battery (-) terminal, a blown fusible link or poor grounding is suspected.
  2. Start the engine and turn on the headlights.
  3. Set the headlights to high beam and the heater blower switch to HIGH, quickly increase the engine speed to 2500 RPM and read the maximum output current value indicated by the ammeter.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.