2003 Kia Spectra Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Toe-In (Total) Adjustment - Rear

  1. Check that fuel tank is full; radiator coolant and engine oil are at specified levels; and spare tire, jack and tools are in their designated positions. Vehicle must be on a level surface.
  2. Measure rear toe angle with a toe angle gauge.
  3. If specification is not met, loosen rear lateral link jam nuts.
  4. Turn lateral link adjuster to adjust left or right rear wheel as needed
  5. NOTE: One turn of link changes toe approximately 0.12 in (3 mm).
  6. Repeat for other side if necessary
  7. Tighten lateral link jam nuts to specified torque

    Tightening torque: 85~115 lb-ft (116~157 Nm, 11.8~16 kg-m)

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.