2003 Kia Spectra Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Feedback Position Sensor

WARNING: This page does not describe the selected car, but rather 22 other vehicles, including the 2021 Kia Sorento, 2020 Kia Soul, 2020 Kia Optima, 2020 Kia Niro, and 2019 Kia Optima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the KDS/GDS (scanner) to the data link connector.
  2. Perform the fully open and the fully closing operation of the EEGR valve by using the actuation test.
  3. Check that the voltage is within the specification.
SPECIFICATION

Item Specification
Sensor Power (V) 5
Pin 3
Opened Voltage (V) 0.75 - 1.25
Closed Voltage (V) 3.85 - 4.15
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.