Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Kia Sorento V6-3.5LFACTORY OEM SERVICE PROCEDURE
Keyless Entry Transmitter: Testing and Inspection
Remote Keyless Entry Programming
1. Connect the DLC cable of the Hi-Scan Pro with the 20-pin Red Kia Connector (P/N 09900 29030).
2. Open the hood and locate the diagnostic connector near the battery. Turn the ignition to the "ON" position.
3. Select Model/Year/Code Saving.
4. Follow Hi-Scan Pro prompts. Press key transmitter buttons for less than one second.
5. Remove the Hi-Scan Pro and verify programming.
Note: A maximum of 2 key transmitters are allowed with this system.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.