2003 Kia Optima V6-2.7LFACTORY OEM SERVICE PROCEDURE

ECM Reprogramming Procedure

Factory service manual diagram




1. Remove program card from the upper slot of Hi-Scan Pro and insert the reprogramming card.

Factory service manual diagram




2. Connect the OBDII cable to Hi-Scan Pro.

3. Connect Hi-Scan Pro to the OBDII connector located under the dash on drivers side.

Factory service manual diagram




4. Turn ignition key to the "ON" position.

5. Turn Hi-Scan Pro on and select "10. OPTIMA 2.5/2.7 BATTERY DRAIN" and press the "ENTER" key.

Factory service manual diagram




6. Select "01. MS 2.5/2.7 BATTERY DRAIN [AUTO]" and press the "ENTER" key.

Factory service manual diagram




7. At the prompt, enter your password "0525" and press the "ENTER" key.

Factory service manual diagram




8. Reprogramming will proceed automatically as shown.

Factory service manual diagram




9. When "REPROGRAMMING COMPLETED" message is displayed, turn ignition key to the "OFF" position. Turn Hi-Scan Pro off and disconnect from vehicle.

10. Start engine and verify normal operation.

Factory service manual diagram




* NOTICE
If reprogramming did not complete properly or was interrupted, repeat process using the following procedure for 01 and 03 model year vehicles. There is no manual mode reprogram for 02 model year, the ECM must be replaced if automatic reprogramming failed.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.