2002 Kia Spectra Base, StandardFACTORY OEM SERVICE PROCEDURE

Synchronizer Ring

  1. Inspect synchronizer ring teeth for damage, wear and cracks.
  2. Inspect tapered surface for wear and cracks.
    Fig 1: Inspecting Synchronizer Ring Teeth For Damage, Wear And Cracks
    G01078612Courtesy of KIA MOTORS AMERICA, INC.
  3. Set synchronizer ring squarely in gear.
  4. Measure clearance between synchronizer ring and flank surface of gear.

    Standard clearance: 0.059 in (1.5 mm)Β 

    Minimum: 0.031 in (0.8 mm)Β 

    Fig 2: Measuring Clearance Between Synchronizer Ring And Flank Surface Of Gear
    G01078613Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.