Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Mechanical Inspection: Compression
Ensure battery is fully charged. Turn ignition off. Disconnect ignition coils. Check engine compression with engine at normal operating temperature at specified cranking speed, all spark plugs removed, and throttle wide open. See COMPRESSION SPECIFICATIONS table.
| Application | (1) Specification - psi (kPa) @ RPM | |||||
|---|---|---|---|---|---|---|
| Optima & Magentis (Canadian) | ||||||
| 2.4L | 178 (1227) @ 250-400 | |||||
| 2.7L | (2) 170 (1200) | |||||
| Rio | 184 (1275) @ 300 | |||||
| Sedona | (2) 170 (1200) | |||||
| Spectra | 193 (1331) @ 300 | |||||
| Sportage | 163 (1124) @ 270 | |||||
|
||||||
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.