Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Kia Rio Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Specifications & Procedures: Pre-Inspection
- Pre-inspection check the tire inflation and set to the recommended pressure if necessary.
- Inspect the front wheel bearing play and correct if necessary.
- Inspect the wheel and tire runout.
- Inspect the ball joints and steering linkage for excessive looseness.
- Place the vehicle on level ground with no luggage or passenger load.
- The difference in height from the center of the wheel to the fender brim between the left and right sides should be within 0.39 in (10 mm).NOTE: The caster and camber is not adjustable. The toe-in is adjustable.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.