Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Kia Rio Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Specifications & Procedures: Inspection
- Raise the front of the vehicle until the wheels clear the ground.
- Turn the wheels by hand and mark a line in the center of each tire tread using a scribing block.
- Place the front wheels in the straight ahead position and lower the vehicle.
- Measure the distance between the marked lines at the front and rear of the wheels.
- Both measurements must be taken at equal distances from the ground.
- The distance between the wheels at the rear should be greater than that at the front by 0.16 +/- 0.12 in (4+/-3 mm).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
