Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Kia Rio Base, AutomaticFACTORY OEM SERVICE PROCEDURE
After-Repair Procedures
- After repair, erase all diagnostic trouble codes stored in the ABS control unit with Hi scan pro. (Refer to Hi-scan pro operating manual).
- Verify that no diagnostic trouble codes are displayed.
- Remove Hi-scan pro from the data link connector.
NOTE:
If Hi scan pro is not available, to erase the diagnostic trouble code from ABS control unit, perform the following instructions.
- With the ignition switch OFF, ground pin "i" and "r" at the underhood data link connector.
- Turn ignition switch ON.
- Rapidly depress and release the brake pedal six times in three seconds to erase any stored DTC's. The ABS warning lamp will flash the all clear code.
- Turn the ignition key OFF and remove the jumper wire at the underhood DLC.
- After DTC's are erased, if there is still problem in the system, ABS warning lamp will stay remain ON. If this occurs, repeat the previous procedure to retrieve trouble codes.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
