Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Kia Rio Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Front Abs Sensor: Installation
- Install ABS sensor and connector.
Tightening torque: 6~8 lb. ft. (8~12 N.m, 0.8~1.2 kg-m)
- Install trim.
- Install the ABS sensor to the attaching clip.
- Install the ABS sensor to the knuckle assembly.
- Connect the negative battery cable to the battery.
NOTE:
A shield wire is used to prevent interruption of the input signal from the ABS sensor. Return the wire to its original position after repair.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.