2002 Kia Optima L4-2.4LFACTORY OEM SERVICE PROCEDURE

ETACS Function

ELECTRONIC TIME AND ALARM CONTROL SYSTEM

OPERATION CHECK OF COMPONENTS
While operating the components, check whether the operations are normal with timing chart.

Factory service manual diagram



ETACS FUNCTION
1. Variable intermittent wiper
Time specification
T(1) : Max. 0.3 sec.
T(2) : Time of wiper motor 1 rotation (0.6 - 0.8 sec.).
T(3) : 2.2 ± 0.2 sec. (VR = 0 kohm) - 10.0 ± 1.0 sec. (VR = 50 kohm)

Factory service manual diagram



2. Washer
1. Time specification
T(1) : 0.3 sec
T(2) : 2.5 - 3.8 sec.

2. This function should be operated preferentially even though the variable intermittent wiper is operating.

Factory service manual diagram



3. Rear window defogger
Time specification
T 1 : 60 msec.
T 1 : 20 ± 1 Min.

Factory service manual diagram



4. Seat belt warning
Time specification
T(1) : 6 ± 1 sec.
T(2) : 0.45 ± 0.1 sec.
T(3) : 0.3 ± 0.1 sec.

Factory service manual diagram



5. Ignition key hole illumination
Time specification
T(1) : 10 ± 1.0 sec.
T(2) : 0 - 10 sec.

Factory service manual diagram



6. Delayed out room lamp
Time specification
T(1) : 5.5 ± 0.5 sec.

Factory service manual diagram



7. Key operated warning
Time specification
T(1), T(2) : 0.45 ± 0.1 sec.

Factory service manual diagram



8. Ignition key reminder
Time specification
T(1) : 0.5 sec.
T(2) : 0 - 0.5 sec.

Factory service manual diagram



9. Outside Door key illumination (Without burglar alarm)
Time specification
T(1) : 10 ± 1.0 sec.

Factory service manual diagram



10. Power window timer
Time specification
T(1) : 30 ± 3 Sec.

Factory service manual diagram



11. Central door lock/unlock (without burglar alarm)
Time specification
T : 0.5 ± 0.1 sec.

12. Central door lock/unlock (with burglar alarm)

Factory service manual diagram



1. When using the door key Time specification
T : 0.5 ± 0.1 sec.

Factory service manual diagram



2. When using the door lock switch
Time specification
T : 0.5 ± 0.1 sec.

Factory service manual diagram



3. When using the transmitter (TX)
Time specification
T : 0.5 ± 0.1 sec.

Factory service manual diagram



13. Tail lamp auto cut

Factory service manual diagram



14. Rear fog lamp control
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.