Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Kia Spectra GSX, AutomaticFACTORY OEM SERVICE PROCEDURE
Bleeding Procedure
WARNING:
Brake fluid system is maintained under pressure. Caution should be taken when bleeding brakes. Brake fluid will damage painted surfaces. If brake fluid contacts a painted surface, rinse with water immediately. If brake fluid contacts eyes, flush with running water for several minutes. Get medical attention if irritation persists. If taken internally, drink water and induce vomiting. Get medical attention immediately.
- Ensure master cylinder is clean of dirt, moisture or any other type of contaminates that may enter master cylinder reservoir. Fill reservoir with clean brake fluid. Remove bleeder cap at caliper and attach clear vinyl bleeder hose onto bleeder plug. Place other end of hose in clean transparent container.
- Bleed brakes in conventional manner. When bleeding brakes, keep fluid level in reservoir to MAX position. During bleeding, depress brake pedal at least 10 times, then hold in depressed position. Keep pedal depressed for 3 seconds. Have assistant loosen bleeder screw, drain fluid and retighten screw.
- For bleeding order, see BRAKE LINE BLEEDING SEQUENCE table. Ensure all air is removed from brake system. Refill master cylinder reservoir after bleeding procedure is complete. Ensure there is no fluid leakage.
BRAKE LINE BLEEDING SEQUENCE
| Application | Sequence |
|---|---|
| Sephia & Spectra | RF, LF, RR, LF |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.