Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Kia Spectra GS, AutomaticFACTORY OEM SERVICE PROCEDURE
Automatic Transmission DTCS
AUTOMATIC TRANSMISSION DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description |
|---|---|
| P0601 | TCM ROM Malfunction |
| P0604 | TCM RAM Malfunction |
| P0705 | Transaxle Range Switch Circuit Malfunction |
| P0712 | TFT Sensor Low |
| P0713 | TFT Sensor High |
| P0716 | Input/Turbine Speed Sensor Signal Malfunction |
| P0717 | Input/Turbine Speed Sensor Circuit Malfunction |
| P0726 | Engine Speed Input Signal Malfunction |
| P0727 | Engine Speed Input Malfunction |
| P0731 | Incorrect 1st Gear Ratio |
| P0732 | Incorrect 2nd Gear Ratio |
| P0733 | Incorrect 3rd Gear Ratio |
| P0734 | Incorrect 4th Gear Ratio |
| P0740 | TCC System Malfunction |
| P0743 | TCC System Circuit Malfunction |
| P0748 | Linear Solenoid Electrical Fault |
| P0753 | Shift Solenoid "A" Electrical Fault |
| P0758 | Shift Solenoid "B" Electrical Fault |
| P0763 | Shift Solenoid "C" Electrical Fault |
| P1115 | Engine Coolant Temperature Signal Malfunction |
| P1121 | TP Sensor Signal Circuit From ECM To TCM |
| P1500 | VSS Signal Malfunction |
| P1700 | O/D OFF Indicator Circuit Malfunction |
| P1800 | Engine Torque Signal Malfunction |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.