2025 Jeep Gladiator Nighthawk, Part Time T/Case ControlFACTORY OEM SERVICE PROCEDURE

Electronic Ignition (Minor): Tune

WARNING: This page is about the Gladiator Big Bear, Full Time T/Case Control, which is a different variant/trim than selected.
Includes: Check compression. Clean or replace Air Cleaner Element and Spark Plugs. Inspect or replace Coil Boots or Ignition Cables.

Applies ToNoteStandard HoursWarranty HoursSkill Level
3.6L EngIncludes: R&I Upper Intake Manifold.3.4B
Combination Procedure: ELECTRONIC IGNITION SYSTEM: Testing:
0.5B
Combination Procedure: FUEL FILTER: Remove & Replace:
3.6L Eng, Fuel Pump Assembly,In TankRefer to Fuel Pump - R&R.B
Combination Procedure: SPARK PLUG TUBE &/OR SEAL: Remove & Replace:
3.6L Eng, Left,All Three2.6C
3.6L Eng, Right,All Three3.2C
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.