Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023WAGONEER L BASE, RWDREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEM3.0L - EMISSIONS CONTROL
2023 Jeep Wagoneer L Base, RWD
3.0L - Emissions Control
2023 Jeep Wagoneer L Base, RWDSECTION 3.0L - Emissions Control
- Special Tools
- Catalyst Monitor
- Crankcase Ventilation
- Evaporative Emissions
- Description And Operation
- Evaporative Emissions System - 3.0L So
- Notes
- System Operation - 3.0L So
- Functional Description - Charcoal Canister
- Functional Description - Delta Pressure Valve
- Functional Description - Evaporative System Integrity Module (ESIM) And Switch
- Functional Description - Fresh Air Filter
- Functional Description - Fuel Tank Pressure (Ftp) Sensor
- Functional Description - Internal Tank Valves
- Functional Description - OBD Vent Valve
- Functional Description - Purge Solenoid
- Functional Description - Vent Blocker Valve (VBV)
- Evaporative Emissions System - 3.0L So
- Diagnosis And Testing
- Technical Specifications
- Canister, Vapor
- Filter, Vapor Canister
- Sensor, Fuel Tank Pressure
- Valve, OBD Vent
- Solenoid, Evaporative Emissions Purge
- Switch, Evaporative Emissions System Monitor
- Valve, Vent Blocker
- Description And Operation
- Exhaust Gas RECIRCULATION
- Permanent Fault Codes
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.