Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023WAGONEER L BASE, 4WDREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMS(ACTIVE VIBRATION CANCELLATION MODULE (AVC) - ELECTRICAL DIAGNOSTICS)
2023 Jeep Wagoneer L Base, 4WD
(Active Vibration Cancellation Module (AVC) - Electrical Diagnostics)
2023 Jeep Wagoneer L Base, 4WDSECTION (Active Vibration Cancellation Module (AVC) - Electrical Diagnostics)
- Diagnostic Code Index
- DTC Troubleshooting
- B154F-23-Lost Crankshaft Pulse Signal-Signal Stuck Low
- B154F-24-Lost Crankshaft Pulse Signal-Signal Stuck High
- B154F-64-Lost Crankshaft Pulse Signal-Signal Plausibility Failure
- C008E-00-Ecu Internal Performance
- C1516-12-Left Vibration Sensor-Circuit Short To Battery
- C1516-14-Left Vibration Sensor-Circuit Short To Ground Or Open
- C1516-92-Left Vibration Sensor-Performance Or Incorrect Operation
- C1517-12-Right Vibration Sensor-Circuit Short To Battery
- C1517-14-Right Vibration Sensor-Circuit Short To Ground Or Open
- C1517-92-Right Vibration Sensor-Performance Or Incorrect Operation
- C152B-01-Left Vibration Cancellation Actuator-General Electrical Failure
- C152B-13-Left Vibration Cancellation Actuator-Circuit Open
- C152C-01-Right Vibration Cancellation Actuator-General Electrical Failure
- C152C-13-Right Vibration Cancellation Actuator-Circuit Open
- C2110-11-Sensor Supply 1 Voltage-Circuit Short To Ground
- C2110-12-Sensor Supply 1 Voltage-Circuit Short To Battery
- C2110-92-Sensor Supply 1 Voltage-Performance Or Incorrect Operation
- C2129-16-Battery Voltage-Circuit Voltage Below Threshold
- C2129-17-Battery Voltage-Circuit Voltage Above Threshold
- C2210-00-Ecu OVERTEMPERATURE
- U0001-00-Can C Bus
- U0002-00-Can C Bus Off Performance
- U0140-00-Lost Communication With Body Control Module
- U0422-00-Implausible Data Received From Body Control Module
- U1600-00-Ecu Application Software Mismatch
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.