Torque Specifications

2023 Jeep Renegade RedSECTION Torque Specifications
TORQUE SPECIFICATIONS

DESCRIPTION N.m Ft. Lbs. In. Lbs. COMMENT
Intermediate Shaft to Steering Gear Bolt 60 44 - * NEW FASTENER:  Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications.
Outer Tie Rod End to Steering Knuckle Nut 40 30 - * NEW FASTENER:  Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications.
Steering Column to Dash Frame Bolts 20 15 -  
Steering Column to Dash Frame Nuts 20 15 - * NEW FASTENER:  Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications.
Steering Gear to Crossmember 110 81 -  
Steering Wheel to Column Nut 50 37 -  
Tie Rod Jam Nut 56 41 -  
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.