Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023GLADIATOR MOJAVE, PART TIME T/CASE CONTROL, AUTOMATIC TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXDTC INDEX (1 OF 2)MODULE, INTEGRATED CENTER STACK (ICS)
2023 Jeep Gladiator Mojave, Part Time T/Case Control, Automatic Trans
Module, Integrated Center Stack (Ics)
2023 Jeep Gladiator Mojave, Part Time T/Case Control, Automatic TransSECTION Module, Integrated Center Stack (Ics)
DIAGNOSTIC CODE INDEX
| DTC | Description |
|---|---|
| B156E-96 | INTEGRATED CENTER STACK (ICS)-COMPONENT INTERNAL FAILURE |
| B157F-2A | BUTTON/KNOB - STUCK |
| B210A-00 | SYSTEM VOLTAGE LOW |
| B210B-00 | SYSTEM VOLTAGE HIGH |
| B210D-00 | BATTERY VOLTAGE LOW |
| B210E-00 | BATTERY VOLTAGE HIGH |
| U0010-00 | CAN INTERIOR BUS |
| U0011-00 | CAN INTERIOR BUS OFF PERFORMANCE |
| U0140-00 | LOST COMMUNICATION WITH BODY CONTROL MODULE |
| U0164-00 | LOST COMMUNICATION WITH HVAC CONTROL MODULE |
| U0184-00 | LOST COMMUNICATION WITH RADIO |
| U0422-00 | IMPLAUSIBLE DATA RECEIVED FROM BODY CONTROL MODULE |
| U0424-00 | IMPLAUSIBLE DATA RECEIVED FROM HVAC CONTROL MODULE |
| U0485-00 | IMPLAUSIBLE DATA RECEIVED FROM RADIO |
| U120E-00 | LOST COMMUNICATION WITH COMFORT SEAT AND WHEEL MODULE |
| U1430-00 | IMPLAUSIBLE DATA RECEIVED FROM COMFORT SEAT AND WHEEL MODULE |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.