Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Module Programming
Pre-June 7th 2021 Build Vehicles built prior to June 7th will be equipped with a Tire Pressure Monitoring System (TPMS) Module.
Post-June 7th 2021 Build The Tire Pressure Monitoring system for vehicles built after June 7th 2021 is integrated by the Radio Frequency Hub (RF Hub). A "Dummy" TPMS module may be installed with the purpose of being a pass-through for the CAN communication lines. The "Dummy" TPMS module cannot be communicated with and is not a factor in the Tire Pressure Monitoring. The programming will reside within the RF-Hub for these models.
Using special tool (special tool #2046300080, Kit, TPM/RKE ANALYZER) and the scan tool, navigate to the TPM system module and then its "Miscellaneous Functions" menu to select and perform the following procedures:
- Program Left Front Tire Sensor ID
- Program Left Rear Tire Sensor ID
- Program Right Front Tire Sensor ID
- Program Right Rear Tire Sensor ID
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.