Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023GLADIATOR MOJAVE, PART TIME T/CASE CONTROL, AUTOMATIC TRANSLABOR TIMESOTHER VARIANTTRANSMISSIONAUTOMATIC TRANSTRANSMISSION ASSEMBLYREMOVAL & INSTALLATION
2023 Jeep Gladiator Mojave, Part Time T/Case Control, Automatic Trans
Removal & Installation
2023 Jeep Gladiator Mojave, Part Time T/Case Control, Automatic TransSECTION Removal & Installation
WARNING: This page is about the Gladiator High Altitude, 3.0L Eng VIN M, Full Time T/Case Control, which is a different variant/trim than selected.
8 SPEED TRANS
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| 3.0L Eng,Automatic Trans | Includes: Check and adjust Transmission Fluid level with fluid temperature within parameters. | 6.8 | C | |
| Combination Procedure: CRANKSHAFT MAIN OIL SEAL: Remove & Replace: | ||||
| 3.0L Eng, Rear,Seal | 0.5 | B | ||
| Combination Procedure: FLYWHEEL: Remove & Replace: | ||||
| 0.3 | C | |||
| Combination Procedure: OUTPUT SHAFT SEAL: Replace: | ||||
| 0.2 | B | |||
| Combination Procedure: TORQUE CONVERTER: Remove & Replace: | ||||
| 0.5 | C | |||
| Combination Procedure: TORQUE CONVERTER SEAL: Remove & Replace: | ||||
| 0.6 | B | |||
| Combination Procedure: TRANSMISSION ASSEMBLY: Replace: | ||||
| Includes: Programming. | 0.8 | C | ||
| Combination Procedure: TRANSMISSION OIL PUMP: Remove & Replace: | ||||
| Includes: R&I Valve Body Assembly. | 2.7 | B | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.