Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023GLADIATOR FREEDOM, FULL TIME T/CASE CONTROLREPAIR AND DIAGNOSISRESTRAINTSRESTRAINTS CONTROL SYSTEMSRESTRAINTS (SERVICE INFORMATION)TECHNICAL SPECIFICATIONSTORQUE SPECIFICATIONS
2023 Jeep Gladiator Freedom, Full Time T/Case Control
Torque Specifications
2023 Jeep Gladiator Freedom, Full Time T/Case ControlSECTION Torque Specifications
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. | COMMENT |
|---|---|---|---|---|
| B-Pillar Impact Sensor Bolt | 8 | - | 71 | |
| Clockspring Mounting Screw | 6 | - | 53 | |
| Driver Airbag To Steering Wheel Bolts | 9 | - | 80 | |
| Front Height Adjuster To Body Bolts | 45 | 33 | - | |
| Front Turning Loop To Height Adjuster Nut | 39 | 29 | - | |
| Front Impact Sensor Nut | 11 | 8 | - | |
| Front Seat Belt Buckle Bolt | 45 | 33 | - | |
| Front Retractor Tensioner Bolt | 45 | 33 | - | |
| Front Retractor Tensioner Bracket To B-Pillar Bolts | 26 | 19 | - | |
| Front Retractor To B-Pillar Bolt | 45 | 33 | - | Do not reuse these fasteners. If removed, a NEW fastener must be installed and tightened to specifications. |
| Passenger Airbag Mounting Bolts | 18 | 13 | - | |
| Seat Airbag Mounting Nut | 10 | - | 88 | |
| Rear Outboard Retractor To Floor Bolts | 40 | 30 | - | |
| Rear Outboard Seat Belt Anchor To Floor Bolt | 40 | 30 | - | |
| Rear Center Retractor Belt To Seat Bolt | 45 | 33 | - | |
| Rear Center Seat Belt Anchor And Right Outboard Buckle To Seat Frame Nut | 40 | 30 | - | |
| Rear Center Buckle To Seat Frame Bolt | 40 | 30 | - | |
| Rear Left Outboard Buckle To Seat Frame Bolt | 40 | 30 | - | |
| Rear Turning Loop To Sport Bar Bolt | 40 | 30 | - | |
| Rear Retractor to C-Pillar Bolt | 40 | 30 | - | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.