Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023COMPASS REDREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANS8F30 AUTOMATIC TRANSMISSION (SERVICE INFORMATION)
2023 Jeep Compass Red
8F30 Automatic Transmission (Service Information)
2023 Jeep Compass RedSECTION 8F30 Automatic Transmission (Service Information)
- Description And Operation
- Diagnosis And Testing
- Standard Procedure
- Technical Specifications
- 8F30 Technical Specifications
- Torque Specifications
- Torque Specifications - BELLHOUSING
- Torque Specifications - FLEXPLATE And Torque Converter
- Torque Specifications - Electric Oil Pump, Drain / Fill Plugs And Valve Body Cover
- Torque Specifications - Shifter
- Torque Specifications - Transmission Mount
- Torque Specifications - Transmission Oil Cooler, Transmission Oil Cooler Manifold And Transmission Oil Heater
- Torque Specifications
- Special Tools
- Removal And Installation
- Cable, Shift
- Cooler, Transmission Oil
- FLEXPLATE
- Heater, Transmission
- Mount, Transmission
- Pump, Electric Transmission Oil
- Seal, Output Shaft
- Seal, Selector Shaft
- Sensor, Speed
- Sensor, Transmission Range
- Shifter, Transmission
- Solenoid, Transmission
- Torque Converter
- Tubes And Hoses, Transmission Oil Cooler
- Valve Body
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.